Teledyne LeCroy HFP1500 - Manual (Page 45)

Operator’s Manual
922252-00 Rev A 39
Appendix A
Performance Verification Test Record
This record can be used to record the results of measurements made during the performance
verification of the HFP1500 High Frequency Probe.
Photocopy this page and record the results on the copy. File the completed record as required by
applicable internal quality procedures.
The section in the test record corresponds to the parameters tested in the performance verification
procedure. The numbers preceding the individual data records correspond to the steps in the
procedure that require the recording of data. Results to be recorded in the column labeled "Test
Result" are the actual specification limit check. The test limits are included in all of these steps.
Other measurements and the results of intermediate calculations that support the limit check are to
be recorded in the column labeled "Intermediate Results".
Permission is granted to reproduce these pages for the purpose of recording test results.
Probe Model: HFP1500
Serial Number:
Asset or Tracking Number:
Date:
Technician:
Equipment Used:
MODEL SERIAL NUMBER
CALIBRATION DUE
DATE
OSCILLOSCOPE
DIGITAL MULTIMETER
FUNCTION GENERATOR
1
N/A
1 The function generator used in this Performance Verification Procedure is used for making relative
measurements. The output of the generator is measured with a DMM or oscilloscope in this procedure. Thus, the
generator is not required to be calibrated.