Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 62)

54
Merlin Mobile User’s Manual CATC SW Version 2.0
need to direct your Master device to attempt a connection to Merlin
Mobile. This will provide Merlin Mobile with the information it
needs to record the piconet.
Once Merlin Mobile has the information it needs, it will begin recording. The
following screen will display:
The recording will end following a trigger event or when you press Stop
Recording button on the screen shown above or when you press the button on the
toolbar.
Step 19
When finished, press Close to close the Recording Wizard.
5.3 Recording in Test Mode
A Test Mode recording allows you to limit the frequency hopping range that
Merlin Mobile will record. Two Test Modes are available: Reduced
Hopping Mode and Single Frequency Mode. Reduced Hopping Mode
limits Merlin Mobile’s recording to the five frequency hops that are
described in the Bluetooth Specification. Single Frequency Mode limits
Merlin Mobile’s recording to a single frequency range that you specify in
the Recording Wizard.
Recording in Reduced Hopping Mode
To record in Reduced Hopping Mode, perform the following steps:
Step 1 Start the Recording Wizard by either pressing the button
or selecting Setup > Recording Wizard from the menu.
The Recording Wizard greeting screen will open.