Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 71)

63
Merlin Mobile User’s Manual CATC SW Version 2.0
6. Recording Options
The Recording Options dialog box provides an alternative method of
setting up a recording to the Recording Wizard, described in the previous
chapter. In this dialog box are all of the settings needed to make a recording.
Once you have selected your recording options, you then select the
recording mode by clicking the down-arrow on the Record button and
selecting from the two mode options: Piconet and Inquiry. Merlin Mobile
will then use the relevant Recording Options for the selected mode. For
example, if you select Piconet recording mode, Merlin Mobile will use the
options from the Piconet page in the Recording Options dialog box.
6.1 Recording Modes
Pressing the down-arrow on the Record button displays a menu with four
Recording Modes:
Selecting one of these modes tells the analyzer what sets of Recording
Options it should use when you begin a recording.
Note: Selecting a Recording Mode from the menu does not cause the
analyzer to begin recording. To begin recording, you must press the
Recording button itself.
Piconet recording
Selecting Piconet, configures Merlin Mobile to record piconet traffic using
the parameters set in the Piconet page in the Recording Options dialog box.
When you begin recording in this mode, Merlin Mobile will to try to
synchronize to a piconet that matches the Piconet parameters set in the
Recording Options. The recorded traffic is captured off-the-air.
Inquiry recording
This mode configures Merlin Mobile to record Inquiry traffic. When setting
the Merlin Mobile to Inquiry recording, the system is ready to perform a
Bluetooth 'General' or 'Dedicated' inquiry, according to the parameters