Acumen INSTRUMENTS CORPORATION DATABRIDGE(TM) SDR2-USB - Manual (Page 21)

SDR2-USB Configuration Guide rev 1.0 Setup File Reference
19
4
4
4. Setup File
Reference
All SDR2-USB configuration is performed via the setup.txt file in the root
folder of the USB storage device. The setup file is read only when power is
connected to the SDR2-USB, and all settings specified within the setup file
are retained by the recorder indefinitely.
4.1.1 Initial Setup Commands
The CurrentDate= and CurrentTime= setup file lines are used during one-
time initial setup to set the real-time clock’s time and date values. After
including these lines in the setup file, power up the SDR2-USB and press
the record button to synchronize the clock, then re-edit the setup file,
erasing or commenting-out the lines for future use.
CurrentDate: Use this command to set the real-time clock’s date. Date
must be specified in YYYY/MM/DD format (e.g. 2009/06/30 for 30 June
2009).
CurrentTime: Use this command to set the real-time clock’s time. Time
must be specified in 24-hour HH:MM:SS format (e.g. 14:49:00 for 2:49
PM).
// uncomment and update these 2 lines to set the time
// time setting is synchronized on a button press
CurrentDate=2009/06/30
CurrentTime=14:49:00