Acumen INSTRUMENTS CORPORATION DATABRIDGE(TM) SDR2-USB - Manual (Page 8)

Getting Started SDR2-USB Configuration Guide rev 1.0
6
1.2 Before you start
Before you start, be sure you have the following items available:
• DataBridge SDR2-USB
• A 5-30VDC power supply
• RS-232 DB9 serial cable
• The device you wish to record from (serial data source)
1.3 A quick guide to the DataBridge
SDR2-USB
On the front of the SDR2-USB are the USB "A" socket, record button, and
LED indicators. The SDR2-USB can be toggled in and out of record mode
using the record button located on the front panel. The LED indicators
show the SDR2-USB’s current recording status. The data indicator flashes
when data is received and is used to verify data reception from your data
source.
Record Button
Fault Indicator
Data Indicator
Record Indicator
Power Indicator
Figure 1.1. SDR2-USB Front Panel Controls.