Teledyne LeCroy USB2-HSIC Decoder - Manual (Page 15)

Instruction Manual
Customizing the Result Table
Follow these steps to change what data appears in the result table:
1. Press the Front Panel Serial Decode button, or choose Analysis > Serial Decode, then open the Decode
Setup tab.
2. Touch the Configure Table button.
3. On the View Columns pop-up dialog, check boxes for the columns you want to appear in the table. Clear
boxes for any columns you wish to remove. Only those columns selected will appear on the oscilloscope
display.
To return to the preset display, touch Default.
4. Optionally, set a BitRate Tolerance percentage. This will help correct signal jitter while decoding.
5. Touch the Close button when finished.
6. Optionally, on the Decode Setup dialog enter the Table # Rows to display.
NOTE: Keep in mind that displaying several, multiple-row tables will reduce the amount of screen space
available for the waveform grids.
Navigating with the Result Table
Besides displaying the decoded serial data, the result table enables you to quickly Zoom regions of the
decoded waveform and control decoder dialogs.
The first column heading (top, left-most cell of the table header) bears the name of the corresponding
protocol, and the cell's fill color matches the color of the input source. Touching this cell opens the Decode
Setup dialog if it has been closed.
Touching the row number in the first column opens a Zoom of the corresponding region in the decode trace.
Touching any other data cell in the table opens a pop-up menu with several choices of action:
l
Off turns off the decoder .
l
Zoom creates a zoom of the region where the data appears (same as touching the row number).
l
Setup opens the Decoder Setup dialog (same as touching the first column heading).
l
Export exports the decode results table to a .CSV file.
l
Measure displays a choice of PROTObus MAG measurements that can be made on the source signal.
Exporting Result Table Data
You can export the decoder result table data to a .CSV file.
Export files are by default created in the Xstream\Applications\<protocol> folder, although you can choose any
other folder on the oscilloscope or any external drive connected to a host USB port. The data will overwrite the
last export file saved in the protocol directory, unless you enter a new filename.
To export the result table:
1. Press the Front Panel Serial Decode button, or choose Analysis > Serial Decode, then open the Decode
Setup tab.
2. Optionally, touch Browse and enter a new File Name and output folder.
3. Touch the Export Table button.
922295 RevA 13