Tracer TP-9363 PRO-Chek CG AM08045-4 - Manual (Page 5)

5
Getting Started
1. The combustible gas sensor comes installed in the tip of the
PRO-Chek CG’s probe. No installation of the sensor is necessary.
2. Install the two D cell alkaline batteries included (see page 7). Remove
the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need to use a small flat-blade screwdriver to
assist with releasing the latch. Install the two “D” sized DURACELL
®
alkaline batteries as shown in Figure 1, with the positive terminals
pointing toward the end of the handle. Reinstall the battery cover by
aligning it in the grooves on the handle and sliding it up the handle until
it latches.
+ - + -
Figure 1
Properly installed alkaline batteries
DURACELL ® is a registered trademark of Duracell, Inc., Bethel, Connecticut.