TREND 963 Web User Guide - Manual (Page 26)

Using 963 From a Client
963 Web User Guide TC200685 Issue 4 15/01/2009 26
4.3.5 Adjust a Module Parameter
It is possible to adjust certain parameters of the configuration modules within IQ controllers directly from a
schematic page or the Device Viewer.
To adjust a module parameter:
1. Display the page containing a value from the controller whose configuration parameters are to be adjusted
as described in the ‘Display a Schematic Page’ section of this manual.
Or
View the value from the controllers whose configuration parameters are to be adjusted in the Device
Viewer.
2. Right-click the value, and click Edit Item. The View as Points dialogue box is displayed.
3. Right-click the parameter that is to be changed, and click Adjust Point from the menu that is displayed.
The Enter new value for dialogue box is displayed.
4. In the box enter the new value.
5. Click OK, to return to the View as Points dialogue box and then to close the View as Points dialogue
box.