Vestil PPI-90 - Manual (Page 5)

5
1. The hydraulic cycle: oil pump =>combined valve => manual
change valve => cylinder => oil-tank.
2. The pressure regulation: The truck has been regulated by
specialist. Please do not adjust the truck unless it is necessary. If
necessary, regulate the truck with full load by the specialists or
experts.
3. The hydraulic oil: If there is no enough oil in the oil-tank (the
truck cannot elevate and it will make a noise), fill the oil-tank
with hydraulic oil to the 4/5 capacity. It is better to used HL-46
hydraulic specific oil, or you can use HV-32 oil instead.
5) Electrification system
Input voltage: DC-24V (2x12V)260Ah
Drive motor: DC-24V 2500RPM 4.5NM
Hydraulic motor: DC-24V 2400RPM
Moving motor and hydraulic motor adopt DC-24V motors. It is
easy to operate, reliable and safe without pollution. Electrification
serves as the power to lifting or moving.
Electrification system consists of charger => battery => Dc
motor.
Battery serves power supply at work. When you want to charge
the battery, pull the plug out of the plug base in truck, and connect
the plug with the charger and connect the charger to 220V/50HZ-AC
mains. When the charge finishes, disconnect the AC mains before
disconnect the battery and the charger.
6) Safe operation
1. Check the truck’ condition before you operate it. The truck must
be operated in well state.
2. Do not operate this truck unless you are trained and authorized.
The driver must observe the safe operation regulations.
3. Do not operate the truck with riding on it. Never place any part
of your body under the forks or near the moving part when the
forks have been lifted.
Vestil Manufacturing Corp. www.vestil.com 800-348-0868