Vestil SP-175 - Manual (Page 2)

2
Lanyard attachment points
WP- models’
center of gravity
(C.O.G.)
Tine Lock
Welded Angle
Fork Pocket
OPERATION INSTRUCTIONS - WP, SP
You must read and understand all the following instructions carefully before using the work platform.
Consult the manufacturer for any questions not resolved to your satisfaction in this owner’s manual.
ATTACHING THE PLATFORM TO A FORK TRUCK:
Insert the fork truck’s forks all the way into the backside fork tubes (opposite the gate side). Entering from the back side of the work
platform, the forks must extend through the front fork pockets. Attach the platform to the fork truck’s fork carriage with the securing
chain, and capture the heel of the fork with the tine lock underneath the corner of the platform.
CENTER OF GRAVITY AND LOAD LOSS INFORMATION
Vert. C.O.G. (A)
Horiz. C.O.G. (B)
Lost Load (lbs.)
WP-4848 (-DD)
13-1/2”
21-3/4”
240
WP-3648 (-DD)
13-1/2”
21-3/4”
190
WP-3636 (-DD)
15-1/2”
17”
160
SP-175
15”
21-1/2”
210
WP-3737-FD
16 - 1/2”
18”
175
Note: For the 84” high back units, add 12 pounds.
Locked Unlocked
WP tine lock. Pull the pin, then
rotate the tine lock 90° until the
pin locks.
SP-175 tine lock. Install the
pin after the fork is inserted.
Lanyard attachment points
Model SP-175
center of gravity
(C.O.G.)