Vestil SP-175 - Manual (Page 4)

4
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to shipment. However, it is possible that the unit may incur damage during
transit. If you see damage when unloading make a note of it on the SHIPPER RECEIVER.
Remove all packing and strapping material and inspect unit for damage.
IF DAMAGE IS EVIDENT, FILE A CLAIM WITH THE CARRIER IMMEDIATELY!
WARRANTY
This product is warranted for 90 DAYS from date of purchase to be free of manufacturing defects in material and
workmanship. The manufacturer's obligation hereunder is limited to repairing such products during the warranty period,
provided the product is sent prepaid back to the factory.
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse
of the product, use or application contrary to installation instructions, or disassembly, repair or alteration by any person prior
to authorization from a factory representative.
ORDERING REPLACEMENT PARTS
We take pride in using quality parts on the equipment we manufacture. We are not responsible for equipment problems
resulting from the use of unapproved replacement parts.
To order replacement or spare parts for this equipment, contact the factory.
In any communication with the factory please be prepared to provide the platform’s serial number.
ROUTINE MAINTENANCE & SAFETY CHECKS
(A) Before each use inspect for the following:
1.) Proper operation of the tine lock.
2.) Proper operation of the securing chain’s snap.
3.) Proper operation of the gate’s latch and chain.
4.) Obvious damage to, or structural deformation of, the base, handrails, and gate.
5.) Wear or damage to the safety harness lanyard attachment angle.
6.) Wear or possible damage to the safety harness lanyard or its clasp.
7.) (If applicable) Proper attachment of the casters to the bottom of the platform. Bending or damage to the casters.
(B) Inspect monthly for:
1.) Worn, loose, or damaged hardware on the tine lock, safety chains, gate latch, gate hinges, and casters (if
applicable).
2.) Damage to the fork pockets or the optional casters.
3.) The overall condition of the platform.
4.) The integrity of the welds at all joints.
5.) Overall squareness and rigidness of the platform.
6.) Information and warning labels being in place and in good condition.
7.) The need to clean off rust, dirt and debris.
•
Maintenance and repairs are to be done only by personnel qualified to perform the required work.
•
Caution: Do not perform any modifications to the platform without the manufacturer’s approval. Failure to receive
authorization for changes to the equipment could void the warranty.