Vestil SP-175 - Manual (Page 6)

6
1) Mount the supplied 4” square junction box with the short pig tail near the front of the fork truck (see figure
“A”) using the 1/4”-20 x 1” machine bolts and lock nuts provided.
2) Disconnect the wire on the key switch coming from the ignition coil and attach it to one of the receptacle
terminals inside the junction box mounted on the fork truck’s dashboard.
3) Connect the appropriate wire from the ignition
key switch to the other receptacle terminal
inside of the fork truck mounted junction box.
4) Mount the “Emergency Stop” junction box
inside the work platform within easy reach of
the operator/maintenance person.
NOTE: Fork trucks powered by Battery or Diesel fuel:
contact the fork truck manufacturer for installation
instructions.
-----------------------------------------------------------------------------
OPERATING INSTRUCTIONS
FOR USE WITHOUT THE WORK PLATFORM ATTACHED:
1) Plug the 12” long jumper plug into the fork truck mounted
junction box. This will provide the necessary connection
for operation without the work platform attached to the
fork truck.
FOR USE WITH THE WORK PLATFORM ATTACHED:
2) Plug the 20’ coil cord into the fork truck mounted
junction box. This will provide the necessary connection
for operation with the work platform attached. (The
mushroom head pushbutton must be pulled out).
FORK TRUCK
MOUNTED
JUNCTION BOX
TO POSITIVE
SIDE OF COIL
MUSHROOM HEAD
PUSH BUTTON
MALE PLUG
FROM COIL CORD/
WORK PLATFORM
JUMPER PLUG
TO IGNITION
KEY SWITCH
KEY SWITCH
ON FORK TRUCK
DISCONNECT HERE
AND CONNECT TO
FORK TRUCK
JUNCTION BOX
IGNITION/COIL
TERMINAL
MALE JUMPER
PLUG
C
FIGURE “A” FIGURE B:
FORK TRUCK
JUNCTION BOX
FIGURE C:
WORK PLATFORM
JUNCTION BOX
BILL OF MATERIALS
ITEM NO. DESCRIPTION QUANTITY
1. 1/4 - 20 x 1 Machine Bolt 8
2. 1/4 - 20 Lock Nut 8
3. 1/4 Flat Washer 8
4. 1/4 Fender Washer 4
5. Fork Truck Junction Box (pre-assembled) 1
6. Work Platform Junction Box (pre-assembled) 1
EMERGENCY STOP BUTTON
WP-SB
GAS POWERED FORK TRUCKS
INST
ALLA
TION INSTRUC
TIONS