Warner Electric PCBC-825, PCBC-1000, PCBC-1225 - Manual (Page 11)

11 Warner Electric • 800-234-3369 P-205-01
•
819-0474
Note: The 1225 unit is mounted with four drive
pins instead of three as shown in the pictures;
however, the assembly procedure is the same
for either case.
Step 1
Place straight springs (white) over armature
bosses on back side of armature. (Figure 7)
Step 2
Compress the heavy (red) spring on each drive pin
by sliding detent spring towards head of pin.
(Figure 8)
Step 3
Insert assembled drive pins through armature
(entering from segmented side), through straight
(white) springs, and into magnet hub.
Note: Apply Grade "AA" Loctite® Sealant on
pin threads. (Figure 9)
Figure 7
Figure 8
Step 4
Tighten pins until shoulders of pins are against
face of hub. Since threads are class No. 3 fit, pins
may seem to bind.
Straight springs must not get
caught under shoulders of drive pins.
Step 5
Check to see that the armature is completely
compressed against the face of the hub.
Step 6
To set the autogap, slide the detent spring
retainers against the armature face.
Note: This position must not be disturbed
during completion of assembly. (Figure 10)
Figure 9
Figure 10