AEG KB7100000 - Manual (Page 12)

SYMBOL FUNCTION DESCRIPTION
TIME OF DAY Shows the time. To set, change or check the time. Refer to
"Setting and changing the time of day".
Setting the clock
1. Activate the appliance and set an oven function and temperature (not necessary for
Minute minder and Time of day).
2. Touch again and again until the display shows the necessary clock function and
the related symbol, for example Minute minder .
3. Touch or to set the necessary time.
When the set time ends, an acoustic signal sounds for 2 minutes. “00.00” goes on in the
display and the related function indicator flashes. The appliance deactivates automatical-
ly. Touch a sensor field to stop the acoustic signal.
General instruction:
• If you set a clock function, the symbol flashes for approximately 5 seconds. In these 5
seconds, touch or to set the time.
• If you set the time, the symbol continues to flash for approximately 5 seconds. After
these 5 seconds, the symbol comes on. The time starts to count down for Minute mind-
er. For Duration and End the time starts to count down after the function starts.
• If you want to delay the start of the cooking time use End function .
• If you want to end cooking earlier (before end of clock functions) use .
AUTOMATIC PROGRAMMES
WARNING!
Refer to "Safety information" chapter.
Automatic Programmes
For an automatic programme, use the recipes from section "Automatic programmes".
Setting a programme
1. Activate the appliance.
2. Use to access the automatic programmes menu.
3. Use
or to set an automatic programme (P1 to P12).
– The symbol for the function comes on in the display.
– The cooking time and come on in the display.
– Touch the clock control . Then, touch the or control to set the cooking time.
– The oven activates automatically after approximately 5 seconds.
When set time ends, an acoustic signal sounds for 2 minutes. flashes. The oven stops
automatically. Touch a control to stop the acoustic signal.
12 Automatic programmes