AEG KB7100000 - Manual (Page 33)

Installing the oven door
1. Hold the door with one hand on each
side at an angle of approximately 60°
(from the side of the door with the han-
dle turn to you).
2. Push door hinges at the same time into
the two recesses at the bottom of the
oven on the left and the right, as far as
they will go.
3. Lift the door up until you meet the point of resistance and then open it as far as possible.
4. Fully lock the clamping levels on the hinges.
5. Close the oven door.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Solution
The appliance does not heat up The appliance is deactivated Activate the appliance
The appliance does not heat up The time of day is not set Set the time of day. Refer to
"Setting the time of day"
The appliance does not heat up The necessary settings are not
set
Make sure, the settings are cor-
rect
The appliance does not heat up The automatic switch-off is ac-
tivated
Refer to „Automatic switch-
off“
The appliance does not heat up The child safety is activated Deactivate the child safety
The appliance does not heat up The fuse is released Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
The oven lamp does not operate The oven lamp is defective Replace the oven lamp.
"d" is lit in the display and the
oven does not heat up
Fan does not operate
Test mode is switched on Switch off the appliance.
Touch and hold and at
the same time, until signal
sounds and "d" display goes out
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
3
4
4
60
5
What to do if… 33