Warner Electric MCS2000-PSDRV2 - Manual (Page 3)

3 Warner Electric • 800-825-9050 P-2010-7 • 819-0525
Specifications
Model: MCS2000-PSDRV2 Dual Channel/Dual
Voltage Driver
Part Number: 6910-448-110
Power Supply Section:
Input: 100 – 260 VAC, 50/60 Hz., single phase
Ouput: 24 VDC, 3.1 Amps DC
Wiring: 3 Position pluggable terminal block for
AC Input
4 Position pluggable terminal block for DC Output
Power
Reset Mode: Requires power off and then power
on to reset driver
Driver Section:
Input Voltage: 24 Volts DC or 48 Volts DC,
+ / -10%
Output Voltage: 24 VDC or 48 VDC depending
on power supply input voltage.
In Overvoltage mode, output voltage is limited to
48 volts DC for 30 seconds before reducing back
to 24 VDC
Output Current: Maximum of 4.5 amps DC per
channel. Overload capacity to 6 amps maximum
per channel for 30 seconds to be followed by
maximum 3 amps for a minimum period of 120
seconds.
Anti-Residual Output: 10% of input power supply
voltage. Adjustable for each channel.
-2.4 volts DC with 24 VDC power supply input
-4.8 volts DC with 48 VDC power supply input
Analog Input Voltage: 0 to 10 Volts DC on Input
A, or Input B.
When operating with 48 volt DC power, input of 0
to 5 volts corresponds to 24 Volt DC output, and
from 5 to 10 volts input overvoltage mode from 24
to 48 volts DC with timed limitation.
Status and Diagnostic Indicators: 2 LED’s on
each channel indicate normal operation and fault
conditions during operation. One Green and one
Red LED.
Protection Input: Polarity protected to prevent
damage in the event of inversion of DC power
supply voltages.
Protection Output: Short circuit protected during
operation and power up. Output is also protected
from overload conditions. Once short circuit is
detected, drive locks out for 10 msec and resets.
After 4 cycles, drive trips out and requires reset.
Wiring: Via 10 position pluggable terminal block
Operating Temperature: + 104 ° F (40 ° C)
Storage Temperature: -13 ° F to + 131° F
(-25° C to + 55° C)
Enclosure: NEMA 1 (IP 20)
Certifications: CE