Warner Electric MCS2000-DRV2 - Manual (Page 5)

System Wiring
Controllers
The MCS2000-DRV2 will operate with any of the
MCS2000 series Controllers. It will provide interface
between the brakes and the MCS2000-ECA,
MCS2000-CTDA or MCS2000-CTLC Tension
Controls.
Wiring between the various controls will vary
somewhat, but for all practical purposes are
pretty similar.
The MCS2000-DRV2 will operate with any of the 24
volt Warner Electric Tension Brakes or Clutches as
long as the maximum current rating per channel is
not exceeded.
Wiring to the MCS2000-ECA Control
Refer to Figure 2 for wiring hook-ups.
It is recommended that shielded
cable or twisted wire pairs be used to minimize
the possibility of noise affecting either the
controller or driver circuitry. Additionally, lead
lengths should be kept as short as possible.
Note: Also refer to MCS2000-ECA Manual for
exact terminal strip locations and designations.
1. Connect a wire from terminal Out 1 (V) on the
MCS2000-ECA to terminal number 1 InA 0-10
V on the MCS2000-DRV2. Insure that both
terminals are tightened securely.
2. Connect a wire from terminal Out 1 (0V) on
the MCS2000-ECA to terminal number 2 0V
on the MCS2000-DRV2. Insure that both
terminals are tightened securely.
If a dual brake system is to be used, then proceed to
step 3.
If only a single brake is to be used on the
MCS2000-DRV2, then skip to either the 24 volt
brake wiring section, page 8 or the 48 volt brake
wiring section, page 10.
3. Connect a wire from terminal Out 2 (V) on the
MCS2000-ECA to terminal number 3 InB
0-10 V on the MCS2000-DRV2. Insure that
both terminals are tightened securely.
4. Connect a wire from terminal Out 1 (OV) on
the MCS2000-ECA to terminal number 4 OV
on the MCS2000-DRV2. Insure that both
terminals are tightened securely.
5. This completes the wiring between the
MCS2000-ECA and the MCS2000-DRV2.
Double check all wiring before proceeding to
the next section.
6. Proceed to either the 24 volt brake wiring
section, page 8 or the 48 volt brake wiring
section, page 10 of the manual.
Warner Electric • 800-825-9050 P-2010-6 • 819-0524
5