ATEN AS-811P - Manual (Page 18)

AS/2 Auto Switch POWER ON PROCEDURE
3 POWER ON PROCEDURE
3-1
1)
POWER ON PROCEDURE
To reset the AS-81 1 P and AS-41 1 P (w/ buffer card), turn off/on power
switch. AS-41
1
P (w/o buffer card) can be reset by recycling printer
power while it is hooked to a printer.
2) After reset, the input channel’s service LEDs are on. Meanwhile, the
AS/2 is ready for operation and it enters the auto switching mode
automatically.
3-2 AUTO SWITCHING MODE
1) In auto switching mode, all see the input channel’s service LEDs are
on. That means the AS/2 is standing by to get data from all channels.
2) If any input channel requests to be served, the requested channel
LED will be on and the AS/2 will lock on to that channel. At this moment
the output port of AS/2 will’ only serve the locked input channel until
all the input data from the requested channel has been sent out and
also the time out period is up. The time out setting depends on the
current DIP Switch’s Setting of AS/2.
User’s Manual
15