ADIC FastStor Mass Storage Device - Manual (Page 43)

Operation and Maintenance 27
Mode 5 – DENSITY
Mode 5 is used to set the density format of the data cartridge tape. All previously unformatted DLTtape III, DLTtape IIIXT, and
DLTtape IV data cartridges can be formatted to the densities shown in the following table.
Drive Model Data Cartridge Cartridge Density
(native mode)
Cartridge Density
(compressed mode)
DLT 4000 DLTtape III
DLTtape IIIXT
DLTtape IV 2.6, 6.0, 10.0 GB
15.0 GB
20.0 GB 20.0 GB
30.0 GB
40.0 GB
DLT 7000 DLTtape III
DLTtape IIIXT
DLTtape IV 2.6, 6.0, 10.0 GB
15.0 GB
20.0, 35.0 GB 20.0 GB
30.0 GB
40.0, 70.0 GB
DLT 8000 DLTtape III
DLTtape IIIXT
DLTtape IV 2.6, 6.0, 10.0 GB
15.0 GB
20.0, 35.0, 40.0 GB 20.0 GB
30.0 GB
40.0, 70.0, 80.0 GB
Maximum Capacity
Notes
The density menu can only be used with a tape loaded in the drive.
The density of previously recorded DLT data cartridges cannot be changed unless the tape is reformatted which will result
in all data being lost.
The default density of unformatted data cartridges is dependent upon the drive installed in your FastStor, and the type of
tape being used.
❐ To access Mode 5, press the MODE button until the LCD appears as shown:
ensity
1 2 3 4 5 6 7
❐ Press the SELECT button to select Mode 5. The LCD will appear as shown (XX is the lowest native density selectable for
this cartridge):
Fmt XX
1 2 3 4 5 6 7
❐ Press the NEXT or PREVIOUS button to scroll through the density choices. Press SELECT when the desired density setting
is displayed. When your FastStor has completed the command, it will return to the LdR REAdY.