Alto-Shaam AR-6G - Manual (Page 22)

c a r e a n D c l e a n I n G
AR-6G Rotisserie Operation & Care Manual • 20 AR-6G Rotisserie Operation & Care Manual • 20
m a I n t e n a n c e
c h a n G I n G o f l I G h t b U l b s
Prior to opening the various sections, disconnect the
electrical supply and close the gas valve located on the
rear of the appliance.
The electric motor compartment is located at the
left and the gas burner controls at the right of the
appliance. The gas valves and intake manifold assembly
along with various electrical switches are located
behind the control access panel. These compartments
allow access for the repair of various components of the
electrical and gas circuits.
Left and Right Access Panels
• Using a screwdriver, remove the various screws holding
the required outside panel and remove the panel.
• When the repair has been completed, the panel must
be remounted and the screws tightened.
Control Access Panel
(For access to control panel components)
• Remove drip tray assembly.
• Remove bolts that secure access panel.
• Remove access panel.
When the repair has been completed, perform the above
described operation in reverse. Seal the cover in place
with an approved silicone sealant (see page 14).
Rear Access Panel
(For access to electrical components)
• Remove 2 screws from rear access panel.
• Tip access panel back.
o p e n I n G m a c h I n e c o m p a r t m e n t s
The gas appliance is furnished with three 20 watt halogen
bulbs. These bulbs should be replaced with the exact
duplicate or a factory recommended replacement. The
logo area is furnished with three 120 volt, 60 watt bulbs.
D a n G e r
DIsconnect UnIt from
poWer soUrce before
cleanInG or serVIcInG.
c a U t I o n
DO NOT hANDlE NEW BulB WITh
BARE hANDS. WhITE COTTON
GlOvES ShOulD BE WORN WhEN
REplACING BulBS.
c a U t I o n
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
c l e a n I n G & r e s e a s o n I n G c a s t I r o n t I l e s
1. Turn the burners OFF, disconnect unit from power
source and allow the appliance to cool.
2. Using hand protection, remove all cast iron tiles.
3. Using a wire brush clean off any extra food debris.
NOTE: DO NOT soak tiles in water or use soap.
This may cause rusting to occur.
4. Spray each tile with cooking spray to preseason.
5. Replace the cast iron tiles.
6. Turn the units power back on and start
the burners.
7. Run through a normal cooking cycle.
8. Repeat steps 1-7 as necessary.