IEI Integration PPC-5152-D525 v2.10 - Manual (Page 53)

PPC-5152-D525 Falt-bezel Panel PC
Page 39
Step 1: Locate the screw holes on the rear of the PPC-5152-D525. This is where the
stand bracket will be attached. The stand mount retention screw holes are
shown in Figure 3-24.
Figure 3-24: Stand Mounting Retention Screw Holes
Step 2: Align the bracket with the screw holes.
Step 3: Insert the retention screws into the screw holes to secure the bracket to the
PPC-5152-D525. Step 0:
3.10.5 Wall Mounting
To mount the panel PC onto the wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four brackets screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 3-25).