Figure 3-36: arm mounting retention screw holes – IEI Integration PPC-37xxA-N26 v1.00 User Manual
Page 62
PPC-37xxA-N26 Panel PC
Page 46
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 100 mm interface pad. If the mounting arm is not
VESA compliant, it cannot be used to support the PPC-37xxA-N26
panel PC.
Step 2:
Once the mounting arm has been firmly attached to its surface, lift the
PPC-37xxA-N26 panel PC onto the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those in the
PPC-37xxA-N26 panel PC. The arm mounting retention screw holes of the
PPC-37xxA-N26 panel PC are shown in Figure 3-36.
Figure 3-36: Arm Mounting Retention Screw Holes
Step 4:
Secure the PPC-37xxA-N26 to the interface pad by inserting four retention
screws through the mounting arm interface pad and into the PPC-37xxA-N26
panel PC.