IEI Integration PPC-37xx-N270 v2.11 User Manual
Page 61
Advertising
PPC-37xx-N270 Panel PC
Page 49
Figure 4-23: Suggested Panel Cut Out Size for PPC-3708A-N270
Figure 4-24: Suggested Panel Cut Out Size for PPC-3710A-N270
Step 3:
Slide the flat panel computer through the previously cut hole. The chassis at the
rear of the flat panel should slide easily through the hole. Only stop sliding the
panel through the hole when the back of the front aluminum frame is flush
against the panel.
Step 4:
Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 8 panel mounting
clamps for PPC-3708A-N270 and 10 clamps for PPC-3710A-N270.
Advertising