IEI Integration AFL2-W21-H61 - Manual (Page 240)

AFL2-W21A/AB-H61 P a n e l P C
P a g e 221
S te p 1: Hardware and BIOS setup. Refer to Section C.2.1.
S te p 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)
MBR type and Ext3 partition type. Leave enough space on the hard drive to
create the recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,
the Symantec Ghost may not function properly.
While installing Linux OS, please create two partitions:
 Partition 1: /
 Partition 2: SWAP
NOTE:
Please reserve enough space for partition 3 for saving recovery
images.
Figure C-29: Partitions for Linux
S te p 3: Create a recovery partition. Insert the recovery CD into the optical disk drive.
Follow Step 1 ~ Step 3 described in Section C.2.2. Then type the following
commands (marked in red) to create a partition for recovery images.
system32> diskpart