IEI Integration LCD-KIT Series v3.00 - Manual (Page 32)

LCD-KIT
P a g e 23
5.2 Un pa c kin g
5.2.1 P a c ka g in g
When shipped, the LCD-KIT series LCD monitor is wrapped in a plastic bag. Two
polystyrene ends are placed on either side of the monitor. The monitor is then placed into
a first (internal) cardboard box. This box is then sealed and placed into a second (external)
cardboard box. The second box is also sealed. A bag containing accessory items is
placed with the monitor in the internal (first) box.
5.2.2 Un pa c kin g P ro c e d u re
To unpack the LCD-KIT series LCD monitor, follow the steps below:
WARNING:
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the LCD-KIT series LCD
monitor has been properly installed. This ensures the screen is
protected during the installation process.
S te p 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
S te p 2: Open the external (second) box.
S te p 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
S te p 4: Lift the monitor out of the boxes.
S te p 5: Remove both polystyrene ends, one from each side.
S te p 6: Pull the plastic cover off the LCD-KIT series LCD monitor.
S te p 7: Make sure all the components listed in the packing list are present. S te p 0: