IEI Integration DM_Series v2.04 - Manual (Page 61)

DM Series Monitor
Page 47
5.2 Unpacking
5.2.1 Packaging
When shipped, the DM series LCD monitor is wrapped in a plastic bag. Two polystyrene
ends are placed on either side of the monitor. The monitor is then placed into a first
(internal) cardboard box. This box is then sealed and placed into a second (external)
cardboard box. The second box is also sealed. A bag containing accessory items is
placed underneath the monitor, at the bottom of the internal (first) box.
5.2.2 Unpacking Procedure
To unpack the DM series LCD monitor, follow the steps below:
WARNING:
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the DM series LCD monitor has
been properly installed. This ensures the screen is protected during the
installation process.
Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2: Open the external (second) box.
Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4: Lift the monitor out of the boxes.
Step 5: Remove both polystyrene ends, one from each side.
Step 6: Pull the plastic cover off the DM series LCD monitor.
Step 7: Make sure all the components listed in the packing list are present. Step 0: