IEI Integration IOVU-751R - Manual (Page 42)

IOVU-751R-CE5/UX-R10 User Manual
Page 33
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions
of the IOVU-751R-CE5/UX-R10. Take care that the panel section that is cut out
is smaller than the overall size of the frame that surrounds the IOVU-751R but
just large enough for the rear panel of the IOVU-751R to fit through (see
219H219H
Figure
4-12 ).
Figure 4-12: IOVU-751R-CE5/UX-R10 Panel Opening (mm)
Step 3: Slide theIOVU-751R-CE5/UX-R10 through the hole until the frame is flush
against the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the frame.
Figure 4-13: Panel Mounting Clamps