IEI Integration RACK-305G - Manual (Page 3)

RACK-305G QIG IEI Technology Corp. Page 3
INSTALLATION STEPS
To install the RACK-305G chassis, the following installation steps
must be completed:
Step 1: Unpack the chassis.
Step 2: Install the front handles.
Step 3: Remove the top cover and hold-down clamp.
Step 4: Install the PSU.
Step 5: Install the backplane.
Step 6: Install the CPU card.
Step 7: Install the PCI and ISA expansion cards.
Step 8: Install the disk drives.
Step 9: Front Panel cables.
Step 10: PSU cable and interface cable connections
Step 11: Replace the top cover.
The installation steps outlined above are described in detail below.
Please refer to the relevant section.
STEP 1: UNPACK
The RACK-305G is shipped in a plastic bag that is placed inside a
cardboard box. The accessories are also shipped with the chassis.
When you unpack the chassis you must:
Make sure all the accessories and components listed above are
present.
Make sure the chassis has not been damaged in anyway.
STEP 2: FRONT HANDLE INSTALLATION
Two handles are shipped with the RACK-305G chassis. The handles
are installed on the sides, at the front of the chassis. Each handle is
secured to the chassis by four retention screws. To install the
handles, please follow the steps below.
Step 1: Align the retention screw holes on the side of the
chassis with the retention screws in the handle.
Step 2: Insert and fasten four retention screws for each
handle.
Figure 2: Front Handle Retention Screws
STEP 3: TOP COVER AND HOLD-DOWN
CLAMP REMOVAL
3.1: T OP C OVER R EMOVAL
The top cover is secured to the chassis with six retention screws,
three on each side of the chassis. To remove the top cover, please
follow the steps below.
Step 1: Remove all six top cover retention screws. Remove
three retention screws from each side of the chassis.
Figure 3: Top Cover Retention Screws
Step 2: Lift the top cover up gently.
Figure 4: Remove the Top Cover
S
TEP 3.2: H OLD -D OWN C LAMP R EMOVAL
Detach the hold-down clamp by removing the two screws located on
each side of the chassis and lift the hold-down clamp off the chassis.
Figure 5: Remove the Hold-Down Clamp