IEI Integration RACK-305G - Manual (Page 7)

RACK-305G QIG IEI Technology Corp. Page 7
Step 4: Reinsert the 3.5” drive tray, with the installed 3.5” HDD
into the main drive bracket. Make sure that the power
connector and the drive interface connector face the
rear of the chassis and the drive is at the top of the
drive bracket.
Step 5: Reinsert the four, previously removed, 3.5” drive tray
retention screws.
If you want to install a 3.5” FDD drive into the main drive bracket,
follow the steps below:
Step 1: Remove the 3.5” drive tray from the top drive bay in the
main drive bracket. To do this, remove the four
retention screws that secure the 3.5” drive tray to the
main drive bracket and then slide the 3.5” drive tray out
of the main drive bracket.
Step 2: The front of the 3.5” drive tray is covered with a
detachable metal cover. Use your fingers to push the
detachable cover inwards until the cover snaps off the
3.5” drive tray.
Figure 16: Bend off the front cover of the 3.5”drive bracket
Step 3: Place a 3.5” FDD drive into the bracket. Make sure the
FDD is upright and both the 4-pin power connector and
the IDE/SATA drive interface connector are facing the
rear of the bracket.
Step 4: Make sure the PCB on the 3.5” FDD is placed directly
on the bottom surface of the drive bracket and the
4-pin FDD power connector and the IDE/SATA drive
interface connector are facing the rear.
Step 5: Secure the FDD to the drive bracket by inserting four
retention screws (two on each side) through the sides
of the drive bracket and into the HDD.
Step 6: Reinsert the 3.5” drive tray, with the installed 3.5” FDD
into the main drive bracket. Make sure the 4-pin power
connector and the IDE/SATA drive interface connector
face the rear of the chassis and the FDD is at the top of
the drive bracket.
Step 7: Reinsert the four, previously removed, 3.5” drive tray
retention screws.
Step 8.5: Reinstall the Drive Brackets
Once all the drives have been installed into the drive brackets,
reinstall the drive brackets into the chassis. To reinstall the drive
brackets into the chassis, please follow the steps below:
Step 1: Place the main drive bracket into the chassis making
sure that the front of the 5.25” optical drives are facing
out of the chassis and the 4-pin drive power
connectors and IDE/SATA interface connectors are all
facing the rear of the chassis.
Step 2: Reinsert the four, previously removed, main drive
bracket retention screws.
Step 3: Correctly mount the side drive bracket onto the main
drive bracket making sure the 4-pin FDD power
connector and IDE/SATA interface connector both face
the rear of the chassis.
Step 4: Reinsert the two, previously removed, side bracket
retention screws into the top of the side bracket.
STEP 9: FRONT PANEL CABLES
The RACK-305G has the following compotents accessible at the
front.
o 1 x Power LED
o 1 x HDD activity LED
o 1 x Power switch
o 2 x Reset buttons
o 2 x USB ports
o 1 x PS/2 keyboard/mouse
These components are all connected to the CPU card with cables.
To correctly connect these cables, please refer to the technical
documentation that came with your CPU card. The connectors that
are provided with the chassis are listed below.
No. Name
2
USB cable
1
KB cable
1
Power LED cable
2
Reset Switch cable
1
HDD LED cable
1
Power switch cable
Table 4: Chassis Connectors
The pin definitions for the USB cable are shown below