Navigating the serial menu, Configuring network settings, Figure 3.1: com1 properties menu – Avocent LongView IP User Manual
Page 23
Chapter 3: Operations
13
Figure 3.1: Com1 Properties Menu
5.
Press
Enter
to display the serial menu. The Appliance Selection Menu will appear.
6.
Type
1
to enter the Receiver Menu or type
2
to to enter the Transmitter Menu. You will be
prompted to enter a password.
7.
Type the password and press
Enter
.
NOTE: If there is no transmitter connected to the receiver, an error message will display and you will be returned
to the Appliance Selection Menu.
Navigating the serial menu
To navigate the serial menu, type the number or letter that corresponds to the option you wish and
press
Enter
. To exit a menu or screen and to confirm any configuration changes you have made,
type
0
(zero) and press
Enter
.
Configuring Network Settings
NOTE: It is recommended that you configure the network settings for the transmitter before you configure the
network settings for the receiver. Static addressing is the only IP addressing method supported.