Figure 3.2: transmitter main menu, Figure 3.3: transmitter network configuration menu – Avocent LongView IP User Manual
Page 24
14
LongView IP KVM Extender Installer/User Guide
To configure network settings for the transmitter:
1.
Activate the serial menu as described in Accessing the serial menu on page 12.
2.
Choose option
2
to access the Transmitter Menu and press
Enter
. If the password option is
enabled, you will be prompted for a password.
3.
Type the password and press
Enter
. The Transmitter Main Menu will appear.
Figure 3.2: Transmitter Main Menu
NOTE: The Reset Appliance option in the Transmitter Main Menu applies only to network settings.
4.
Press
1
to select the Network Configuration option and press
Enter
. The Network
Configuration Menu appears.
5.
Press
1
to select the Transmitter Network Config option and press
Enter
. The Transmitter
Network Configuration Menu will appear.
Figure 3.3: Transmitter Network Configuration Menu
6.
Press
1
to select the Transmitter IP Address option and press
Enter
. Type a valid IP address.
Press
Enter
to return to the Transmitter Network Configuration Menu.
7.
Configure the network and default network using the same principle.