Acura 08B26-S3V-2000-91 User Manual
Page 3
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
BII 24550 (0209)
3 of 7
6.
Remove the driver’s seat front cover by pulling it
toward you. Take care not to damage the clips.
7.
Route one end of the BUS cable from the radio
opening down through the center console.
CLIP
DRIVER’S SEAT
FRONT COVER
DRIVER’S
SEAT
9.
Locate the slit in the floor carpet just under the
driver’s seat cushion, and pull the BUS cable 14-pin
connector out about 300 mm through the slit.
FRAME
RADIO
OPENING
VEHICLE
HARNESS
BUS CABLE
14-PIN
CONNECTOR
BUS CABLE
BUS CABLE
SLIT in FLOOR
CARPET
DRIVER’S
SEAT
about
300 mm
BUS CABLE
8.
Continue routing the BUS cable along the center
console and the driver’s seat.
10. Secure the BUS cable to the vehicle harness with a
wire tie in the area shown.
BUS CABLE
VEHICLE
HARNESS
TAPE
WIRE TIE