Acura 08B26-S3V-2000-91 - Manual (Page 5)

© 2002 American Honda Motor Co., Inc - All Rights Reserved. BII 24550 (0209) 5 of 7
SPRING
ADJUSTING PIN
LEFT LOCKING
COVER
(included with
CD Changer kit)
RIGHT
LOCKING
COVER
(included
with CD
Changer
kit) SPRING
ADJUSTING PIN
(H: Horizontal)
(V: Vertical)
Installing the CD Changer
15. Carefully unpack the CD changer. Remove the three
shipping clips, and discard the shipping cover. Install
an adhesive seal (included with the CD changer kit)
over each of the three clips holes. Save the shipping
clips for your customer in the event the unit needs to
be serviced.
16. Visually check the position of the spring adjusting
pin on both sides of the CD changer. If the spring
adjusting pins are not in the horizontal (H) position,
move the pins to the horizontal (H) position by
sliding them up with an awl.
17. Remove the adhesive backing from the “L” and “R”
locking covers, and attach them to the sides of the
CD changer. Align the diagonally opposite holes with
the H and V positions.
18. Install the right changer bracket on the CD changer
using two 4 x 8 mm washer-screws, and the two
wire clips. Install the left changer bracket on the CD
changer using two 4 x 8 mm washer-screws.
NOTE: With the changer mounted in this location,
the locking covers do not indicate right and left
correctly. Mount the CD changer brackets in the
direction shown.
WIRE
CLIP
RIGHT
CHANGER
BRACKET
LEFT
CHANGER
BRACKET
4 x 8 mm
WASHER-
SCREW
4 x 8 mm
WASHER-
SCREW
WIRE
CLIP
FRONT
SHIPPING CLIPS (3)
SHIPPING
SEALS (3)
SHIPPING COVER
(Discard.)