Probuilt Professional Lighting ECO Uplight - Manual (Page 4)

GETTING ECO Uplight STARTED
All award-winning UPLIGHT products are designed and manufactured to the highest
standards. Used and maintained correctly they will provide dependable long-term
operation. Please follow these simple steps to prepare your ECO Uplight for use:
STEP 1 – INITIAL INSPECTION
Upon unpacking the ECO Uplight it should be inspected for damage
STEP 2 – ASSEMBLY
The ECO Uplight comes ready to use. However the one fixing eyelet bagged and
attached to the diffuser. Ensure this is removed and stored in a safe place or
attached to the ECO Uplight before use.
STEP 3 – OPENING THE TRIPOD
Slacken the thumb screw on the sliding collar.
Apply downwards force to the collar to open and deploy the tripod legs. For
maximum stability the sliding collar will sit directly above the main body section of
the Eco Uplight.
Tighten the thumbscrew to clamp the collar in position.
To stow the tripod carry out the above steps in reverse order.
STEP 4 – TESTING
1. Take the ECO Uplight to the work area and position it so that it is away from
pedestrian traffic but near enough to the work site to provide sufficient light.
2. Locate a switched power supply socket appropriate to the voltage of the
ECO Uplight unit that you have (refer to ‘Electrical Safety Guidelines’).
Ensure that this socket is switched OFF.
3. Insert the plug of the ECO Uplight into the power supply socket, and locate the
retainer. Switch ON the power supply. Please note that there is no ON/OFF
switch on the unit – ECO Uplight is controlled from the power supply.