American Megatrends MAN-STOR-ITX27-CLI - Manual (Page 20)

StorTrends® iTX Software CLI (Command Line Interface) (Version 2.7) User’s Guide 14
iSCSI Configuration
Note:
Targetname input: Only the suffix portion of the targetname is required.
For example: “iqn.1991-10.com.ami:itx001a2b3c4d5e2006:test1” . The user needs to input only “test1”.
Command Argument Description
get iscsi -t/--type {tgtstatus}
-n/--targetname <targetsuffix>
For example: get –t tgtstatus –n target1 iscsi Gives the status of the target as
enabled or disabled.
get iscsi -t/--type {tgtname} Gets the iSCSI target name. This
value is not configurable and is
unique to the iTX device.
For example:
iqn.1991-
10.com.ami:itx0030482c8d788a7e
activate iscsi -t/--type {portal}
-p/--ipaddress <Ipaddress of the target machine>
-g/--portaltag <portal tag>
For example: activate –t portal –p 10.15.1.1 –g 3
iscsi Activates the specified iSCSI
portal. You have to specify a portal
tag at the time of activation of the
portal.
deactivate iscsi -t/--type {portal}
-p/--ipaddress <ipaddress of the target machine> Deactivates the specified iSCSI
portal.
enable iscsi -t /--type {tgt}
-n/--targetname <target suffix> Enables the specified target.
disable iscsi -t/--type {tgt}
-n/--targetname <target suffix>
For example: cli disable –t tgt –n newtgt iscsi Disables the specified target.
start iscsi To start the iSCSI service.
stop iscsi For example: stop iscsi To stop the iSCSI service.
set iscsi -t/--type {params}
-o/--choiceno {0-12}
-l/--value <value>
For example: set –t params –o 1 –l 256 iscsi. Sets specified iSCSI Login
negotiation parameters.
The possible values are:
1. FirstBurstLength (0-256 KB,
default=256)
2. MaxBurstLength (must be less
than #1, default=256)
3. MaxRecvDataSegmentLength
(0-256KB, default=256)
4. MaxConnections (0-4,
default=2)
5. DefaultTime2Retain (0-3600,
default=20 sec)
6. DefaultTime2Wait (0-
3600,default=2 sec)
7. InitialR2T (0-1, default=No,0)
8. MaxOutStandingR2T (1-8,
default=1 sec)
9. ErrorRecoveryLevel (0-2,
default=2)
10. ImmediateData (0-1,
default=1,yes)
11. DataPduInOrder (0-1,
default=1,yes)
12. DataSeqInOrd (0-
1,default=1,yes)
get iscsi -t/--type {lunwritecachemode}
-v/--volumename <volume name>
-c/--containername <containername> Gets the Write Cache mode for the
specified disk.
set iscsi -t/ --type {lunwritecachemode}
-v/--volumename <volume name> Sets the Write Cache mode for the
specified disk.