Rapid-Air SERVO FEED: 200T & TX - Manual (Page 15)

14
RESET JOB PARAMETERS
The reset job parameters routing should be used with special caution. We
incorporated it as a user function for two reasons.
The first reason is if a problem caused the displayed parameters to be garbled
because of a program glitch, then by resetting the job parameters the problem could
be cleared.
The second reason is if there were a number of different jobs in memory that were
no longer required, then by resetting the job parameters, all the job numbers would
be reset to their default values, which includes putting all zeros in the feed length
and strokes per minute area of the program.
CAUTION!! CAUTION!! CAUTION!!
Keep a hard copy record of program numbers and data associated with them for
reference if needed. If this function is used in a way other than what it was designed
for then all previous data is lost and cannot be recovered.
To enter this function, turn off the program by depressing the master stop button.
Turn on the program again and push and hold the “clear entry” key, once the
program has started the following screen will be displayed.
**DEFAULT VALUE SETUP
PRESS F1 TO RESET TO
DEFAULT VALUES, PRESS
F4 TO IGNORE CHANGES
**Once F1 has been pressed then all data that had been entered will be reset.
PROGRAM NUMBER DISPLAY
Each servo unit that is shipped has a program number assigned to it. If a problem
occurs and cannot be solved by reloading the program then you will be asked the
program number associated with this servo.
To view the program number, press and hold the “back space” key during the power
up sequence. The program number will be displayed for about 30 seconds. Please
find and write down the program number in case it is needed in the future.