Rapid-Air SERVO FEED: 200T & TX - Manual (Page 2)

1
RAPID-AIR START UP SECTION (100-200-300 S SERIES)
Congratulations on purchasing a Rapid-Air Servo. Not only did you receive a complete
servo unit but also telephone support by one of our engineering staff to guide you on
using the new servo to it’s maximum capability.
In order to maximize your learning time and trouble shoot any interface problems. We
would like to request that the following items be complete before calling us.
1. Servo unit should be completely installed and aligned to a die on the press.
2. 220 Vac electrical wiring should be in place and unit turned on.
3. All interface switches should be wired and tested.
4. Air if needed should be connected and ready to be used.
5. All servo interface questions should be directed to your distributor first then to
Rapid-Air. Please call 815-397-2578 and ask to have these questions directed to the
proper personnel.