Rapid-Air PALLET MASTER (PMD) HIGH SPEED: 35, 50 & 100 SERIES - Manual (Page 6)

Instruction for wiring Pallet Master Decoiler after shipping
1. See drawing (fig RA-1)
2. Feed wires from base through hole in control arm.
3. Bolt control assembly to base with (4) 1/2-13 x 3/4 screws provided.
4. Take off control sub-panel access cover by removing (14) screws.
5. See drawing (fig RA-4) for 230 V system
See drawing (fig RA-5) for 110 V system
6. Connect wiring shown on drawing (fig RA-4) or (fig RA-5) which ever applies.
7. Replace cover.
8. Refer to Rapid-Air operating instructions to set up pallet master decoiler.
6