ALESIS QS6.2 - Manual (Page 98)

C
MIDI Supplement
96
MIDI Implementation Chart
Function Transmitted Recognized Remarks
Basic
Channel Default
Changed 1 — 16
1 — 16 each 1 — 16
1 — 16 each
Memorized
Mode Default
Messages
Altered Mode 3
X
* * * * * * * *
Mode 3
X
Note
Number
True Voice 0 — 127
* * * * * * * *
0 — 127
0 — 127
Velocity Note On
Note Off O
O O
O
After
Touch Keys
Ch’s X
O O
O
Pitch Bender O O
Control
Change 0 — 120 O
O
Prog
Change
True # O 1 0 — 127
* * * * * * * *
O 1 0 — 127
0 — 127
System Exclusive O O
System
Common Song Pos
Song Sel
Tune X
X
X X
X
X
System
Realtime Clock
Commands X
X X
X
Aux
Messages Local On/Off
All Notes Off
Active Sense
Reset
GM On X
X
X
X
X O
2
O
X
O
2
O
Notes
1
O, X is selectable
2 Recognized as ALL NOTES OFF
Mode 1: OMNI ON, POLY Mode 3: OMNI OFF, POLY O : Yes
Mode 1: OMNI ON, MONO Mode 4: OMNI OFF, MONO X : No
General MIDI
There are three MIDI registered parameter numbers (RPNs) which the
QS will recognize in Mix Mode when General MIDI is enabled. These
are:
• MIDI Registered Parameter 0 (Pitch Bend Sensitivity): This will
affect the Pitch Wheel Range parameter of all four Sounds of the
Program on the received MIDI Channel of the Mix.
• MIDI Registered Parameter 1 (Fine Tune): This will affect the Pitch
Detune parameter of all four Sounds of the Program on the received
MIDI Channel of the Mix. Also, when this RPN is received, the QS
will automatically make sure that all four Sounds of the Program have
their Detune Type parameter set to “Normal” (Program Edit Mode,
Pitch Function, Page 3).
• MIDI Registered Parameter 2 (Coarse Tune):This will affect the
Pitch Semitone parameter of all four Sounds of the Program on the
received MIDI Channel of the Mix.