Atlantis Land Line Interactive UPS A03-PS651 _MX01 - Manual (Page 28)

OnePower Line Interactive UPS (EN)
A03-PS651 Pag. 24
• Wear rubber gloves and boots.
• Do not lay tools or metal parts on top of batteries.
• Disconnect charging source prior to connecting or disconnecting battery
terminals.
Before beginning the replacing of the battery You have to switch-off all the device
and detach AC cable from the wall receptacle.
1. Place the unit on a flat surface.Press the battery cover latch and remove the
battery cover. Step 1, Step2 and Step 3.
2. Gently Pull the battery out of the UPS. Step 4.
3. Loosen the black wire from the negative (-, Black) terminal and red wire from
the positive (+, Red) terminal. Step 5.
4. Connect the battery leads to the new battery (small sparks at the battery
connectors are normal during connection).
5. Slide the battery into the UPS.
6. Close gently the front panel. Step 6.
7. Dispose of the old battery properly at an appropriate recycling facility.
NOTE: Once the battery is disconnected, the loads are not protected from power
outages.