Faststor 22 barcode reader module installation – ADIC 22 User Manual
Page 6
4
FastStor 22 Barcode Reader Module Installation
The Barcode Reader module is installed by connecting it to the interface connector on the right inside panel of your FastStor 22.
✔
Remove the Barcode Reader module from the packaging and check that the reader is securely attached to the mounting
bracket.
You do not need any tools to install the Barcode Reader module in your FastStor 22. A thumbscrew and interface connector on the
mounting bracket secure it to the right inside panel of your FastStor 22 directly to the right of the
I/E Slot
. Follow the installation
instructions below to install the optional barcode reader module.
1.
Power down your FastStor 22.
2.
Remove the FastStor 22 AC line cord from the AC source outlet.
3.
Open the front door of your FastStor 22.
4.
Remove all data cartridges from your FastStor 22.
5.
Locate the interface connector on the inside right panel of your FastStor 22 directly to the right of the
I/E
Slot
.
Barcode Reader Module Mounting Location
Interface Connector