Diagnostic menu, Barcode labels, Barcode function – ADIC 22 User Manual
Page 8
6
Diagnostic Menu
Your FastStor/FastStor 22 automatically senses the presence of the Barcode Reader at power-up and enables the barcode read
function. The application software can start scanning barcode labels as soon as the FastStor/FastaStor 22 is powered-up. When the
Barcode Reader module is installed, a new
BARCODE
function appears under the FastStor/FastStor 22
DIAGNOSTIC MENU
. The
BARCODE
function is not available if the Barcode Reader module is not installed.
Barcode Function
The
bARCOdE
function, available under the
dIAG MENU
whenever the Barcode Reader module is installed,
is used to
enable/disable the module. If disabled, the barcode reader is not available to the application software.
Note
The
bARCOdE
function default setting is
bCOdE ON
.
The
dIAG MENU
is accessed by pressing and holding first the
NEXT
button and then the
MODE
button for approximately 5
seconds.
dIAG MENU
will appear on the LCD. The FastStor/FastStor 22 will automatically exit the
dIAG MENU
and return to
LdR
REAdY
if the keypad is idle for 30 seconds.
1.
After entering the
dIAG MENU
, access the Barcode function by pressing the
MODE
button until
bARCOdE
appears on the
LCD.
2.
Press the
SELECT
button.
bCOdE ENAb
will appear on the LCD.
3.
Press the
SELECT
button.
bCOdE ON
will appear on the LCD.
4.
To disable the Barcode Reader module, use the
NEXT
or
PREVIOUS
keys to select "
bCOdE OFF
". Press the
SELECT
button
to execute the change.
Barcode Labels
After installing the Barcode Reader module, before inserting any data cartridges into your FastStor or FastStor 22, affix the barcode
labels to the cartridges as described:
❐
To install the barcode labels, position the label with the numbers upright, as shown in the illustration below, sliding the label
under the ridges on the sides of the cartridge recess.
Note
Do not peel label from liner. Use perforations to separate labels.
Refer to Chapter 3 of your Installation and Operating Guide to load the media into your FastStor or FastStor 22.
Installing a Barcode Label