Progressive International Electronics Configurator - Manual (Page 10)

PI Configurator Installation Guide
Version 2.0 April 2005
Page 8
For Dispensers Using Model 67 or 67B DBox
The 67 and 67B DBoxes are similar. Be sure to determine model number from nameplate before
attempting to connect to this device or damage may occur.
1. Disconnect the Tokheim console (if applicable) from the 67/67B distribution box and connect
the Tokheim 67/67B style PI Configurator to the 67/67B DBox and to the PIE product, using
the appropriate cables supplied by PIE. Refer to Diagram: PIE Product to PI Configurator to
Tokheim 67 DBox following this section.
2. Connect wires to the 67 connection box according to Tokheim’s instructions. Program the
dispensers as though they were connected to a MIMS-IV.
3. Locate dispenser connection cable (with DB9S hooded connector on one end and a round
connector on the other end). Connect the dispenser connection cable to the connector on
the Tokheim configuration box. Screw-lock this connector to the box with screws provided.
4. Locate the other end of the dispenser connection cable. Connect the round connector from
the PIcon cable to the cable from the 67 DBox. Cables must be screw-locked together. The
connection must be in a sheltered environment, protected from harsh elements such as
water, extreme heat or cold, etc.
Diagram: PIE Product to PI Configurator to Tokheim 67 DBox