Progressive International Electronics Configurator - Manual (Page 2)

ii
PI Configurator Manufacturer's Warranty
Progressive International Electronics, Inc. (SELLER) warrants to the Purchaser of fuel control equipment manufactured by Seller
against defects in material or workmanship for one (1) year from date of shipment. Seller will replace or repair defective parts or
replace and issue credits to the Purchaser's account in accordance with the following Conditions of Warranty.
CONDITIONS OF WARRANTY
1. Credit will be applied only when the completed warranty request form and the defective parts are received and inspected.
Decisions to repair or replace defective equipment are solely at the discretion or PIE.
2. When parts shipments are made prior to receiving the required warranty request and defective parts, they will be billed to the
Purchaser.
3. In all cases, approved warranty requests will be expedited by issuing the appropriate credit to the Purchaser's account and
shipping replacement parts.
4. Credits will not be issued for parts and no cash refunds for warranty credits will be made.
5. All components and parts must be returned to the factory prepaid, and in turn, replacement components and parts will be
returned prepaid by the factory.
6. Seller's warranty applies only if the equipment has been installed and used in accordance with Seller's instructions. The
warranty is void if any unauthorized alteration or addition has been made to the equipment or if it has been subject to
damage caused by abuse, misapplication, accident or improper operation.
7. The Seller's liability for any damages, including contribution and indemnification, arising out of or in any way connected
with the supplying of the equipment or its use, shall not in any case exceed the cost of repair of the equipment as herein
provided. Upon expiration of the warranty, all such liability, as well as any other liability, shall terminate.
8. Nothing contained herein shall make the Purchaser, its agents or employees, an agent or representative of Seller and Seller
assumes no responsibility of any act, omission, representation or warranty by the Purchaser or anyone else except as
expressly stated herein.
9. The final Decision as to the validity of any claims arising under the warranty shall be determined solely by the Seller.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING,
BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE WHICH EXCEED THE AFORESAID OBLIGATIONS AND ARE HEREBY DISCLAIMED AND EXCLUDED
BY SELLER.
W A R N I N G
Warning: Installation must comply with the National Electrical Code, as well as Federal, State, Local and all applicable codes.
Warning: Do not install PI Configurator units in a volatile, combustible or explosive atmosphere. All PI Configurator units
must be protected from severe vibration, extreme temperatures and excessive humidity.
Any peripheral equipment is to be installed over a non-hazardous location.
Any peripheral equipment connected to the PI Configurators must be UL listed.
The PI Configurator must be plugged into a dedicated 115 VAC wall socket.
History of Documentation
Version 1.0 — 2003
Initial Release
Version 2.0 — April 2005
Moved Kraus and Bennett sections to other manuals