Progressive International Electronics Configurator - Manual (Page 3)

PI Configurator Installation Guide
Version 2.0 April 2005
Page 1
System Installation
System Installation Warnings
Safety hazards are inherent with all electrical equipment. Standard precautions must be taken at all
times during installation and operation of the PI Configurator units. In addition to normal electrical
precautions, the following points should be noted during installation.
C Installation must comply with National Electrical Code, as well as Federal, State/Provincial,
Local, and all applicable codes.
C High voltages are present in the PI Configurator components, as well as the equipment to
which it is attaching. To prevent personal injury or equipment damage, disconnect all power
before proceeding with installation.
C PI Configurators must be installed in nonvolatile, noncombustible, nonexplosive areas. The
box must be protected from severe vibration, extreme temperatures and excessive humidity.
C All PI Configurators and associated equipment must be installed in nonhazardous locations
and must be UL-listed, using standard communication.
For Use in USA
Installation of the PI Configurator and associated equipment must comply with the requirements of
the National Electrical Code (NFPA 70), the Automotive and Marine Station Code (NFPA 30A), and
all Federal, State, Local, and applicable safety codes.
For Use in Canada
Installation of the fuel control equipment must comply with the requirements of the Canadian
Electrical Code, the Flammable and Combustible Liquid Code, and all Federal, Provincial, State,
Local, and applicable safety codes.
The installation of the systems covered by this manual in conjunction with equipment not UL Listed has not been evaluated by the
Underwriters Laboratories and is outside the intended use of this equipment. Warning: All dispensing equipment discussed in this
manual is not UL Listed and the combination has not been evaluated by Underwriters Laboratories.