Progressive International Electronics EZ Wire DBox - Manual (Page 8)

PI DBox Installation Guide
Version 5.0 January 2012
Page 4
For applications using PIE products:
For stand-alone applications, see description later in this section.
3. Set the jumper (JP2 position) to the desired interface type. The PiPort interface is used by
Progressive’s PIcon console. The RS232 and X Port interfaces are used by the FuelDirect Fuel
Control Solution.
4. Referring to the diagram of the front panel which follows, connect the PIcon to the PiPort
connector or connect the FuelDirect to the RS232 connector. If using ethernet connectivity,
connect to the X Port. Refer to the IP Addressing section at the end of this manual for further
ethernet instructions.
5. Proceed with programming of system.