Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 28
Chapter 1 Overview
1-15
L: Hanger
A hanger for temporarily hanging the GP unit on a
wall.
M: CF Card Access Lamp
N: 3-Position Enable Switch
The switch provides three positions: A position
where the switch is not pressed (released), a
position where the switch is pressed to the
intermediate position, and a position where the
switch is pressed to the innermost position (fully
pressed).
O: Hand Strap Attachment Slots
P: GP3000H Cable Connector (with Connector
Cover)
Connects the GP3000H dedicated cable.
Q: Touch Pen
R: Wall Adapter Attachment Slots
To mount the GP unit to a panel or commercially
available arm, attach the GP3000H dedicated wall
hanging adapter (optional) to this hole.
S: Insertion hole (with cover) for Function
Switch Sheet.
T: Neck Strap Attachment Slot
• Do not operate or conduct wiring of the
GP unit, with the GP unit hung on a wall.
Otherwise, the GP may fall, resulting in
injury or damage to the equipment.
•
The following is recommended to be used as
pairs for this hanger;
-A
ϕ
7 or less, rod-shaped or S-shaped hook
-M4 pan-head machine screw with head
diameter
ϕ
7 or less.
-Panel thickness: 1 to 1.6mm [0.04 to 0.06
in.], Panel width: 14mm [0.55 in.]
Access
Lamp
Indicates
Green
ON
Indicates that a CF Card is
inserted and DIP Switch 4 is set to
ON, or that the CF Card is being
accessed.
Green
OFF
Indicates that DIP Switch 4 is set
to OFF, or that no CF Card is
inserted.
F
G
M
Q
O
P
N
Right Side
Rear
R
L
O
T
S