Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 32)

Chapter 2 Specifications
2-3
2.1.3 External Specifications
Inst
alla
tion
Grounding
Grounding resistance of 100 Ω 2 mm 2 or thicker wire, or your
country's applicable standard.
(Same for FG and SG terminals)
Structure
*1
*1 Even though the GP unit's level of resistance is equivalent to the standards shown in
the specification, oils that should have no effect on the GP can possibly harm the unit.
This can occur in areas where either vaporized oils are present, or where low
viscosity cutting oils are allowed to adhere to the unit for long periods of time. If the
GP's front face protection sheet becomes peeled off, these conditions can lead to the
ingress of oil into the GP and separate protection measures are suggested.
Also, if non-approved oils are present, it may cause deformation or corrosion of the
front panel's plastic cover. Therefore, prior to installing the GP be sure to confirm the
type of conditions that will be present in the GP's operating environment.
Rating: Equivalent to IP65f
Cooling Method Natural air circulation
Weight Approx.
1,000g [2.2 lb.] max. (GP without a Key Switch, unit only)
1,050g [2.3 lb.] max. (GP with a Key Switch, unit only)
External
Dimensions
W 224 mm [8.82 in.] X H 174 mm [6.85 in.] X D 87.1 mm [3.43 in.]
(except an Emergency Switch)