Proface FP3900 - 19 Flat Panel" - Manual (Page 3)

3
Part Names
C D E F G
H
Front View
Rear View
Bottom View
A,B
J I
A: TFT Color LCD
Acts as a display monitor for your host.
B: Touch Panel
Allows you to switch screens or write
data to the host.
C: Power Connector (Socket)
Provides the input and ground terminals
for a power cable.
D: Setting Switch
By opening the cover, the Dip switches
and slide switch are seen. Each switch
can set a operation mode.
E: Analog RGB Connector
Connector for analog RGB interface
F: DVI-D Interface Connector
Connector for DVI-D interface
G: Serial Connector
Connector for serial (RS-232C) interface.
Used for sending touch panel data to the
host.
H: USB Connector (Type B)
Connector for USB interface. Used for
sending touch panel data to the host or
used as an upstream port for USB-HUB.
I: Front LED
Used to indicate the condition of the
power supply, a backlight burnout or
image signal input.
J: Front USB Connector (Type A)(FP3900-
T41-U only)
A downstream port for embedded USB-
HUB in conformity with USB2.0/1.1
standard, which is used for connecting
USB devices. Connect the upstream port
of the USB-HUB (H:USB connector) to
the Host PC for Front USB connector
use.