Ramp rate for channel a, Ramping function for channel b, Ramp rate for channel b – Watlow Series 998 User Manual
Page 64: Rt`a] [rp`b] [rt`b, Setup-global
4.36
WATLOW Series 998 User’s Manual
Setup Menus, Chapter 4
Ramp Rate for Channel A
Set the rate of heating for channel A.
[rt`A] This prompt appears when [rP`A] is set to [Strt] or [StPt].
Default
↓
[```0]
…
[`100]
…
[9999]
degrees/minute
[rt`A]
[rt`A]
[rt`A]
Ramping Function for Channel B
Select when channel B will enter ramping mode.
• [Strt] Activates ramping on power up only.
• [StPt] Activates ramping on power up and any set point change.
[rP`b] This prompt always appears.
Default
↓
[`OFF]
[Strt]
[StPt]
[rP`b]
[rP`b]
[rP`b]
Ramp Rate for Channel B
Set the rate of heating for channel B.
[rt`b] This prompt appears when [rP`B] is set to [Strt] or [StPt].
Default
↓
[```0]
…
[`100]
…
[9999]
degrees/minute
[rt`b]
[rt`b]
[rt`b]
Setup-Global
[Rt`A]
[RP`b]
[Rt`b]
NOTE:
Lower display alter-
nately flashes
{`rp`}
and lower
display value when
ramping is in
process.